February 13, 2005
The Blast Door decals are too wide to fit on a 11
inch sheet so I had to split it in half. But it still
prints on the same page. |
|
 |
 |
|
February 13, 2005
Place the left side of the Door decal onto your foamcore.
Be carefull, it's hard to peel off once attached. |
|
 |
|
|
February 13, 2005
now place the Right Side Decal. Align ith the Edge
first and then let some of it overlap all while making
sure the center frames align properly. |
|
 |
|
|
February 13, 2005
Since cornners are tricky, I had a great idea...
First do a rough cut of the inside in order to toss
away the center of the foamcore rectangle. |
|
 |
|
|
February 13, 2005
Now get a hole puncher and place it along the curved
edges of the Decal. |
|
 |
|
|
February 13, 2005
Make holes at each corner of the Blast door. |
|
 |
|
|
February 13, 2005
Now use your Xacto Pen to connect the dots and make
a clean cut along the Decals edges. |
|
 |
|
|
February 13, 2005
You will now have a nice clean edge like this. |
|
 |
|
|
February 13, 2005
Once you connect all the dots, you will have a perfectly
clean Front Frame. |
|
 |
|
|
February 13, 2005
Looking cool placed alongside the Diorama wall :)
You think you are finished? HA HA HA, come on, did
Han jump through such a small door :P
Time to make the Doors.
|
|
 |
|
|
