February 13, 2005
Take your Blast Door frame and grab one of the cut
rectangles. |
|
 |
 |
|
February 13, 2005
Glue the 2 pieces together using your Hot Glue gun.
Repeat this step once more with the other frame and
rectangle. |
|
 |
|
|
February 13, 2005
Now grab a regular frame and rectangle piece. |
|
 |
|
|
February 13, 2005
just as you did with the Front Frames, glue the 2
pieces together. Repeat again to have 2 similar pieces. |
|
 |
|
|
February 13, 2005
You should now have 4 Blast Door pieces, 2 foamcore
thickness. |
|
 |
|
|
February 13, 2005
take your Xacto and carefully, with a NEW blade (to
make smooth edges) follow the top layer as a guide.
For the rounded corners, you might want to switch
to the PEN Xacto knives with the pointy triangle blades.
Watch your fingers !!! |
|
 |
|
|
February 13, 2005
After several minutes, you now have your fron Blast
Door frame completed. |
|
 |
|
|
February 13, 2005
Do the same for the regular frames. these are a little
easier since there are no round edges. |
|
 |
|
|
February 13, 2005
Poke out the bottom after you cut all around. You
should now have a 2 layer thick middle frame. |
|
 |
|
|
February 13, 2005
once all your cuts are done, you would have 4 frames...
2 with decals (front and rear)
2 regular middle frames. |
|
 |
|
|
