March 05, 2005
Take one of the cut out centers to save on foamcore
costs. |
|
 |
 |
|
March 05, 2005
Slice up some little .5 cm strips but don't worry
they are only for support and no need to be accurate. |
|
 |
|
|
March 05, 2005
Now cut those strips in half. |
|
 |
|
|
March 05, 2005
Let's make some Ventilation Pipes :) Grab a straw
and crush the end folding it in half. |
|
 |
|
|
March 05, 2005
Now you should be able to insert the crushed end
into a secong straw's opening. |
|
 |
|
|
March 05, 2005
Continue this until you have enough length to reach
all 4 cut outs. Should take about 3 straws. Trim off
the excess.
Make sure to NOT cut TOO short. |
|
 |
|
|
March 05, 2005
Take a straw and cut it to fit the remaining hole
on the left. |
|
 |
|
|
March 05, 2005
There are 5 straws in the photo but you need only
FOUR.
2 Black and 2 Greys. I got these at IKEA, they are
already colored. how cool is that :)
If you have plain straws, you can paint them the
correct colors. |
|
 |
|
|
March 05, 2005
Remember those little strips we cut? Glue them with
your Hot Glue Gun to the base of the Shaft floor.
|
|
 |
|
|
March 05, 2005
Place 1 behind each column. this way you won't see
the straw supports when looking at the ventilation
from the front. |
|
 |
|
|
