February 26, 2005

For movie accuracy apply TWO decals on the RIGHT side. Leave the left side blank. This space will be covered with a LARGE curved panel.

Of course, if you don't want to make or place a curved panel, you can cover the left side with TWO more regular decals.

February 26, 2005

Flip your floor back to it's proper side. The MacTac should be on top - duh - LOL.

February 26, 2005

Take your left wall and secure it to the floor using your Hot Glue Gun. Make sure to allign it flush with the edge of the floor. DO NOT leave a gap.

February 26, 2005

Now take the Right Wall and glue it to the floor with your Glue Gun. As in the left wall, make sure it is alligned flush with the floor base.

February 26, 2005

Now cut out a 15.5cm X 12cm piece of Black Foamcore. Cut 7 copies to be exact and Hot Glue the FIRST one to the floor base next to the Left Wall.

No need to put glue between the pieces for now. If you use glue only on the bottom, that will help you get a better fit.

February 26, 2005

Glue a SECOND rectangle next to the FIRST. Use the Hot Glue only to secure the panel to the floor.

Just to be safe, take a piece of tape and place it behind the 2 wall sections near the top.

February 26, 2005

Take another of the 12cm X 15.5cm rectangles...

February 26, 2005

...and stick on TWO decals. For movie accuracy, a Trapeze and Neon section are used.

You can select any decal of your choice if you prefer.

February 26, 2005

Now Hot Glue this wall unit next to the TWO blank wall units. Secure the units together with a small piece of tape near the rear top of the Foamcore.

February 26, 2005

Grab TWO more blank wall panels and Hot Glue those to the floor. Use the tape to keep everything in place until you get out the glue.