February 20, 2005

Flip over the Floor Base exposing the sticky side of the MacTac.

February 20, 2005

Using a NEW Xacto blade, slowly go all the way around the floor cutting off the excess MacTac.

February 20, 2005

Once you pull off all excess and flip the floor back to it's proper side, there you have it. Darth Vader and Obi-Wan's Jedi Duel floor :)

February 20, 2005

Print out the decals needed for the Jedi Duel room from the downloads section. Of course at C3, these will already be printed and ready for you should you wish to construct this room.

I print mine on Avery Full Page Labels. This prevents the need for glue. Just peel and apply :)

February 20, 2005

The LEFT WALL:

Cut out 32cm X 24cm BLACK foamcore. If you can't find black in your area, white is ok, you can paint it with latex grey before applying the decals.

February 20, 2005

Peel the wax paper on the back of the sheets and apply the 4 Decals in the order shown.

These tall Decals were my prototypes for this room. As you can see, they don't quite reach the top. i will be doing slight modifications soon for the final C3 and Download sections.

February 20, 2005

Take out your Hot Glue Gun and attach the Left Wall to the floor base.

Make sure to allign the front FLUSH with the Left corner...

February 20, 2005

... We want to keep a small gap on the Right side of the wall (see the green arrow) to fit the next wall corner piece.

February 20, 2005

Next up, cut out Two identical pieces of 9.5cm X 32cm rectangles. Best to use Black Foamcore to hide the Decal seams.

February 20, 2005

Take these 4 Decals and apply them to the front walls.

Note: The Black Panel Box goes on the LEFT wall. and remember to keep a .25cm space on each OUTER wall.

The final Decals will fit all the way to the top of the walls.