March 10, 2007
We are ready to attach the roof to the Hutt Walls
and Tree Trunk.
Try and find a placing that looks nice and even on
both sides. |
|
c |
 |
|
March 10, 2007
Now place some Hot Glue on the TOP CENTER flap ONLY
and press against the Tree Bark.
Hold with your fingers for a few seconds until it
stays stuck to the bark. |
|
 |
|
|
March 10, 2007
After the center is attached, you can move on to
the TWO remaining side flaps. |
|
 |
|
|
March 10, 2007
This is how the Roof will lokk like when you are
done.
Cool isn't it ? :) |
|
 |
|
|
March 10, 2007
Again, here is a better view on how to apply the
Hot Glue to the flaps. |
|
 |
|
|
March 10, 2007
To make sure the roof realy sticks well to the Bark,
you can place one hand INSIDE the tree and press against
the Roof.
Don't press TOO hard. You don't want to make a hole
in the roof - LOL. |
|
 |
|
|
March 10, 2007
So our Hutt is now complete. We can now move on to
detailing the rest of the platform. |
|
 |
|
|
March 10, 2007
Oh yeah, but first, we need to make the underneath
supports.
Take your Hot Glue and place a drop on ONE end of
a bamboo twig. |
|
 |
|
|
March 10, 2007
Lean it up against the UNDERSIDE of the platform
then move the bottom of the twig (where the glue is)
against the Tree Bark. |
|
 |
|
|
March 10, 2007
Continue and repeat this steap a few times until
you go all the way around.
There isn't any real number of supports you NEED
to place. Use your eyes to make it look good.
You can now turn the tree upside down, and place
some Hot Glue Drops on the other end of the twigs
(the ones touching the platform) |
|
 |
|
|
