March 11, 2007
Now you do not need these extra wires poking out
the top so we need to chop them off with your wire
cutters. |
|
c |
 |
|
March 11, 2007
Follow the blue arrows, you can now see that the
wires have been removed.
John is now holding the 2nd reverse platform (created
from the reverse side of the first platform.
The left hand goes BEHIND the tree and the right
hand stays close to the end of the first spiral. |
|
 |
|
|
March 11, 2007
Now you can criss cross the metal wires until ... |
|
 |
|
|
March 11, 2007
... the TWO platforms CONNECT as one. Now secure
the edges of the second platform to the tree using
your Hot Glue gun. |
|
 |
|
|
March 11, 2007
You can place your hand and arm inside the top of
the tree to act as a brace as the glue cools off as
to not tear the bark. |
|
 |
|
|
March 11, 2007
Flip your tree upside down and measure about 1 inch
or so on the overlap. See between the green lines.
|
|
 |
|
|
March 11, 2007
Now with your Hot Glue gun, attach the 2 wires together.
Repeat until all 4 wires are secure. |
|
 |
|
|
March 11, 2007
Now flip your tree back to it's proper side. There
is no way the ewoks will fall through the connection
now :) |
|
 |
|
|
March 11, 2007
After the curve there is a slight straightway to
allow the curve to continue to the other level as
indicated by the green arrows. |
|
 |
|
|
March 11, 2007
Here you can see the underside of the Hut and where
the wires criss crossed together.
You can also see how to attach the supports, leaning
them against the inside of the wires.
|
|
 |
|
|
