March 11, 2007
Now at the bottom of the 2nd level we need to stop
the incline and return the platform to a level surface
in order to attach another Hut if you wish to.
Go to the edge of the platform curve and retrace
your steps until you have formed HALF a circle. This
is where you will bend upwards. |
|
c |
 |
|
March 11, 2007
Once bent, your platform will look like this. |
|
 |
|
|
March 11, 2007
If you decide to place a 2nd Hut, you need to place
the Hut Height Template to make sure the roof doesn't
collide with the top spiral platform.
Once you have the proper height, then use the Hot
Glue to attach the remaining base to the tree. |
|
 |
|
|
March 11, 2007
Use the wire cutters to remove the excess wires from
the platform edges. |
|
 |
|
|
March 11, 2007
Now is a good time to fix any gaps that may have
been caused by attaching the platform to the tree.
Simply a few drops of Hot Glue |
|
 |
|
|
March 11, 2007
And place your bamboo pole into the slot. The platform
is now repaired. |
|
 |
|
|
March 11, 2007
If you decide to create another Hut, then place your
Tree template about 2 inches from the base's edge.
|
|
 |
|
|
March 11, 2007
One at a time, glue lollipop sticks to the Bamboo
in front of the arrows on the template. |
|
 |
|
|
March 11, 2007
All 6 supports are secured, it's time to attach your
wall. |
|
 |
|
|
March 11, 2007
Start with the 2 center sticks. Place some Hot Glue
along the front edges all the way down. |
|
 |
|
|
