February 16, 2007
We now must now make your template for the Hutt Wall
Supports.
Measure 6.5 inches X 3 inches and measure halfway
from the top, meaning 1.5 inches. |
|
 |
 |
|
February 16, 2007
Place and align The INSIDE foamcore piece (the one
you removed when cutting your Flooring Template) and
trace the circle onto your template.
You can see where I traced following the RED arrows.
Then from those same corners, draw a round shape to
the center tip on the opposite side. You should have
what looks like a happy smile :) |
|
 |
|
|
February 16, 2007
Place the smile ontop of your Ewok Floor Base. Make
sure to allign the inner cut out to the floorings
edges.
I have added arrows to show you where you want to
attach the 6 lollipop sticks. |
|
 |
|
|
February 16, 2007
Place some Hot Glue on the tip of the lollipop stick. |
|
 |
|
|
February 16, 2007
And hold it in place ON TOP of the FLOOR logs.
DO NOT glue to the FOAMCORE guide. That would be
bad ;p |
|
 |
|
|
February 16, 2007
When I removed the template, I decided to drip some
extra Hot Glue onto the sticks to secure them tighter
in place. |
|
 |
|
|
February 16, 2007
You should now have a completed Floor AND 6 lollipop
sticks wall support. |
|
 |
|
|
February 16, 2007
Now take some paper. I found this ultra cool textured
paper that already looked like the wall surface you
see in the film.
If you dont have this, you can take a paper towel,
and soak it with water, and then use a brush with
latex brown watered down paint to dab color into the
towel. Once dried it should look similar.
|
|
 |
|
|
February 16, 2007
Cut your sheet to 12 inches wide X 4 inches tall.
For this Hutt we are placing a Doorway. From the
top you should keep 1.25 inches from the center. The
doorway is 2 inches.
Draw a curve at the top and cut out with scissors
or your Xacto.
|
|
 |
|
|
February 16, 2007
Place your centered sheet on top of the 2 top lollipop
sticks.
|
|
 |
|
|
