February 17, 2007
There we go, we have a cool Hutt Roof. Well almost
;p |
|
 |
 |
|
February 17, 2007
Flip the roof over and you will better see on the
left that not all the brissels are at the same length.
This is good. What is NOT good is if the stick out
1 or more inches like on the right side. |
|
 |
|
|
February 17, 2007
Take your scissors or wire cutters and trim off the
excess brissels.
DO NOT cut them in a straight line, you don't want
them to look like your neighbour who's mon would place
a bowl on his head to give him a haircut. LOL
Spread the brissles and cut them 2-3 at a time at
various lengths. |
|
 |
|
|
February 17, 2007
And there you go. Much better length and not too
even. |
|
 |
|
|
February 17, 2007
Now gently bend over your tabs. You will be using
these to attach the roof to the tree bark. |
|
 |
|
|
February 17, 2007
Take the roof and drop some Hot Glue on the CENTER
tab ONLY. |
|
 |
|
|
February 17, 2007
Align the roof and press against the tree. You can
stick your other hand inside the tree from the top
to allow for better pressure against the tree. |
|
 |
|
|
February 17, 2007
Once cooled off and secure, Apply Hot Glue to the
2 remaining tabs on the left side. |
|
 |
|
|
February 17, 2007
Press both tabs against the tree bark. |
|
 |
|
|
February 17, 2007
Hold for a few seconds until the glue cools down. |
|
 |
|
|
