October 10, 2004
Gently fold the cut Decal over the edge of the Lower
Layer of the table. Don't go too fast or you risk
RIPPING the Decal. Not Good :P
|
|
 |
 |
|
October 10, 2004
Repeat the same process for all 12 Control Panel
Notches.
Remember to Take Your Time.
Your Table should look like this when yu are done
fcutting and folding. |
|
 |
|
|
October 10, 2004
Control Panels !!! This is the icing on the cake.
Print the Control panels from the Download Section.
I will post them later this week.
Use sticky Label Paper Sheets if available. They
are really cool and save on glue. |
|
 |
|
|
October 10, 2004
Peel the backing or apply Glue Stick and press against
CARDBOARD, NOT on Foamcore. It is too thick. We want
a thinner panel then the .5cm Foamcore dimension. |
|
 |
|
|
October 10, 2004
Cut out your 12 Control Panel Carboard inserts. Don't
they look cool? :) |
|
 |
|
|
October 10, 2004
Now we don't want ugly cardboard peeking through
the table top so get out your black marker and cover
all 4 sides of the Control Panels.
Do Not stay TOO LONG on the same area, the pen will
tend to leak and the Decal and Cardboard will absorb
the excess and make blotches. |
|
 |
|
|
October 10, 2004
Now take a Control Panel and place it into one of
it's grooves.
Take your Hot Glue Gun and squirt a small amount
of glue inside the opening between the Foamcore and
Cardboard. |
|
 |
|
|
October 10, 2004
Carefully press down onto the Lower Layer. The Hot
Glue will smoosh with the Control Panel and keep it
from falling out. |
|
 |
|
|
October 10, 2004
Repeat the Hot Glue Smooshing 11 more times until
all 12 Control panels are in place. Looking nice if
I do say so myself :D |
|
 |
|
|
October 10, 2004
Find the Center of your table using your Angle Ruler. |
|
 |
|
October 10, 2004
Poke a hole through the Table Surface. This is where
the Centerpiece will fit into. |
|
 |
|
October 10, 2004
I had an extra Darth Vader Interrogation Droid that
just happens to be the same size as the Movie Centerpiece,
So I simply cut off the Stand and removed the plastic
pincers and probes.
BE CAREFULL when cutting the plastic stand. you need
A LOT of pressure and can hurt your fingers if done
too quickly. |
|
 |
|
October 10, 2004
Now stick the Probe into the hole in the center of
the table. |
|
 |
|
October 10, 2004
Ta-Dah !!! Your Conference Table is now complete.
What do you think? Look pretty cool doesn't it? |
|
 |
|
October 10, 2004
A small peak at what our figures will look like in
the finished Diorama. All thats missing is Walls and
some Chairs... |
|
 |
|
|
