July 14, 2008
Then place some more Hot Glue to the opposite side
of the ceiling. |
|
 |
 |
|
July 14, 2008
Now with the ceiling secure, the Rear door arch will
not slip and slide.
You can now put some Hot Glue along the Right wall
edge and gently press the door frame down onto it
to secure it in place.
Do not place the Hot Glue all the way up the wall
!!! |
|
 |
| If you do so it will harden too quickly
and you wont get a clean, flush finish. Just
the few first inches as you see with the Yellow Arrows at a
time.
|
|
July 14, 2008
Keep your fingers pressed tighly until the Hot Glue
cools down. |
|
 |
|
|
July 14, 2008
Now take some black art paper and cut 2 long strips
measuring 6cm by the length of the cardboard sheet. |
|
 |
|
|
July 14, 2008
Now start smudging your gluestick in a wave pattern
to cover a great even surface. |
|
 |
|
|
July 14, 2008
Then gently use the gluestick to glide along the
door frame edges.
Follow the yellow arows :) |
|
 |
|
|
July 14, 2008
Now press the cardboard agaisnt the inside walls.
START at the CENTER of the wall pressing where you
see the RED arrow.
Then follow the YELLOW arrows outward. On the FLAT
walls and ceiling, press the cardboard against the
full wall edges.
|
|
 |
When you reach the curves, use your Index
finger and ONLY press against the Front and Rear EDGES.
This is so that you will get a smooth CURVED wall effect.
|
|
July 14, 2008
After you glue one piece, do the same until the entire
inside archway is covered. At one point the cardboard
will overlap.
Cut the longest piece to fit just over the center
of the other. The Dotted Yellow line.
|
|
 |
Use gluestick on the underside of the TOP cardboard
and press along against the bottom cardboard.
|
|
July 14, 2008
Now for Decals...
Start with the doorway ceiling. Peel away or gluestick
the decal and align the neons center ceiling, FLUSH
with both sides of the door front and rear.
Press down in the center first #1 |
|
 |
Then spread out towards the outside #2
and #3. Then using your Index finger, gently round the
corners #4 and #5.
|
|
July 14, 2008
Cut out the decals for the doorway sides. |
|
 |
|
July 14, 2008
Align the Neons between the floor and ceiling arches. |
|
 |
|
July 14, 2008
Do the same with the opposite side wall. Make sure
to align the center of the decals to make it seem
it is one continuous graphic line. |
|
 |
|
July 14, 2008
Grab a little piece of Black Mac Tac. The same plastic
that is used for the Death Star floors.
For this Door base you just need a xxcm x 6cm piece. |
|
 |
|
July 14, 2008
Peel back the Mac Tac backing to expose it's adhesive
side and carefully place centered along the doorway
floor. |
|
 |
|
July 14, 2008
Now grab the door you cut away and slowly and gently
place it inside the archway.
Since it is the same cut, it should fit like a glove. |
|
 |
|
|
