July 14, 2008
... and placed the Exhaust on top of it.
Since the rings were made for napkins, the toilet
paper roll slides in nicely. Use some Hot Glue to
keep it in place and prevent it from sliding down
to the floor. |
|
 |
 |
|
July 14, 2008
Next I took 4 toothpics and cut off the points on
one end. |
|
 |
|
|
July 14, 2008
Carefully poke the pointy ends into the foamcore. |
|
 |
|
|
July 14, 2008
And then all that is left is to put a quick coat
of latex grey paint.
Bring one of your decals to the paint store to try
and match the color as close as possible :)
Your Exaust port is now complete. I think it's an
Exhaust port LOL |
|
 |
|
|
July 14, 2008
Now for the floor, cut out a 51.5cm X 54cm piece
of foamcore. |
|
 |
|
|
July 14, 2008
Peel your black glossy Mac Tac vynil flooring and
carefully place it onto your floor piece. |
|
 |
|
|
July 14, 2008
Press outwards as you go along making sure to try
avoid leaving any air bubbles. |
|
 |
|
|
July 14, 2008
Flip your foamcore upside down and trim away all
the excess Mac Tac. |
|
 |
|
|
July 14, 2008
You now have a nice Death Star shiny floor :)
There is a white gap on the left due to the width
of the Mac Tac roll, but since this part will be covered
with the walls, I thought it was a waste to cut another
Mac Tac sheet to cover this area. |
|
 |
|
|
July 14, 2008
Start with placing the DOOR wall, which is the same
as the CLOSET wall.
Allign the door FLUSH with the floor base (circle
1) and leave a SMALL .5cm gap (circle 2) on the corner
edge as a space for the other wall's foramcore thickness. |
|
 |
|
July 14, 2008
Here you can better see the 1/2cm gap on the RIGHT
side of the Door wall. |
|
 |
|
July 14, 2008
This is the start of your Diorama and the main entrance
to the room.
If you want to turn it into a playset, you could
have the door loose so that you could open and close
it and could have the closet doors open and close. |
|
 |
|
July 14, 2008
Next the Right wall.
Cut a piece of foamcore 15.5cm tall X 54cm wide. |
|
 |
|
July 14, 2008
Measure ONE decal width (6cm) and start applying
your stickers at that line.
Use the same decals as in the photo if you want movie
accuracy. |
|
 |
|
July 14, 2008
Now take this wall and use Hot Glue to secure it
to the floor of the diorama.
Make sure to align it FLUSH with the back of the
Door. I drew a pointy red line to show you how the
wall lines up perfectly. |
|
 |
|
|
