April 02, 2005
Place some Decals on the top and we have a second
Docking Bay wall :) Woo hoo !!! |
|
 |
 |
|
April 02, 2005
Here you can see how it fits next to the first wall. |
|
 |
|
|
April 03, 2005
Let's move onto some floor detail. We need to make
an elevator shaft.
Start with cutting a 28cm X 12cm rectangle. Measure
4.5cm from each corner. Connect these corner markings
and you should get 45 degree angles.
Chop those off. |
|
 |
|
|
April 03, 2005
Cut off 2 rectangles 12cm X 15cm, 4 pieces 15cm X
6cm and 2 pieces 15cm X 18cm.
Attach the first 12cm piece to the floor base and
then 2 angled 6cm pieces on each side.
Make sure they all connect and flush at the base. |
|
 |
|
|
April 03, 2005
Now use some tape to keep them temporarely in place. |
|
 |
|
|
April 03, 2005
Hot Glue the 18cm piece to one of the 6cm angles. |
|
 |
|
|
April 03, 2005
Repeat on the other side. |
|
 |
|
|
April 03, 2005
2 more Angle 6cm pieces are Hot Glued to the baase
and Taped at the top. |
|
 |
|
|
April 03, 2005
All that is missing is the last 12cm piece. |
|
 |
|
|
April 03, 2005
Hot Glue that one to the base and attach 2 pieces
of Tape at each side near the top. |
|
 |
|
|
