April 03, 2005
The white Arrows show you the seam where the TWO
floors meet up.
The TOP Piece is actually a copy of the first without
the Elevator hole. |
|
 |
 |
|
April 09, 2005
Now grab the Elevator Floor piece you cut out earlier... |
|
 |
|
|
April 09, 2005
... and place it on the STICKY SIDE of a sheet of
D-C-FIX Glossy Black Vinyl.
Use your X-Acto Knife to cut along the excess trim
on all sides. |
|
 |
|
|
April 09, 2005
Once you FLIP your piece, it will look like this. |
|
 |
|
|
April 09, 2005
Now place it Glossy Side UP into the Elevator Shaft. |
|
 |
|
|
April 09, 2005
Slowly press down till you reach the floor.
You may have to wiggle it as it goes down to remove
the trapped air underneath. |
|
 |
|
|
|
April 09, 2005
I print my decals on a FULL size SHEET of Sticker
Paper. This avoids use of Glue sticks.
I Peeled back the protective backing and carefully
applied the first corner.
Align the TOP of the Wall Patern with the Floor
line, then once that is smoothed out, SLOWLY BEND
the TOP SQUARE towards the floor until contact. |
|
 |
|
|
April 09, 2005
Do the FOUR CORNER decals first.
Remember to push OUTWARDS on the Decal Floor Tops
and NOT inwards towards the Elevator Shaft. |
|
 |
|
|
April 09, 2005
Now peel back the SIDE WALL decals and apply it
between the 2 corners.
GO SLOW, make sure they allign properly. |
|
 |
|
|
