February 26, 2005
Glue a SECOND rectangle next to the FIRST. Use the
Hot Glue only to secure the panel to the floor.
Just to be safe, take a piece of tape and place it
behind the 2 wall sections near the top. |
|
 |
 |
|
February 26, 2005
Take another of the 12cm X 15.5cm rectangles... |
|
 |
|
|
February 26, 2005
...and stick on TWO decals. For movie accuracy, a
Trapeze and Neon section are used.
You can select any decal of your choice if you prefer. |
|
 |
|
|
February 26, 2005
Now Hot Glue this wall unit next to the TWO blank
wall units. Secure the units together with a small
piece of tape near the rear top of the Foamcore. |
|
 |
|
|
February 26, 2005
Grab TWO more blank wall panels and Hot Glue those
to the floor. Use the tape to keep everything in place
until you get out the glue.
|
|
 |
|
|
February 26, 2005
Take the SIXTH 15.5cm X 12cm rectangle... |
|
 |
|
|
February 26, 2005
...and apply TWO decals. You know the drill for movie
accuracy by now :P |
|
 |
|
|
February 26, 2005
Use the Hot Glue and secure this last left wall piece
to the floor baase. It should arrive flush with the
foamcore cut. |
|
 |
|
|
February 26, 2005
Don't panic about the blank wall panels. You will
be placing TWO LARGE round panels against wall #2
and #3.
4 SMALL round panels will fit on walls #5 and #6
Of course if you don't want movie accuracy and prefer
regular decals, that's cool too. |
|
 |
|
|
February 26, 2005
Now that the wall panels are all fited in place,
we can reinforce the wall and bond the sections together.
Simply drip some Hot Glue INTO the cracks formed
in the back of the wall panels. |
|
 |
|
February 26, 2005
Once cooled off, the piecs will be impossible to
fall apart. Well, unless you STEP on your Dioramaa
:P LOL. |
|
 |
|
February 26, 2005
Take the LAST 15.5cm X 12cm rectangle piece... |
|
 |
|
February 26, 2005
...and apply TWO more decals. |
|
 |
|
February 26, 2005
Use the Hot Glue to secure it to the floor base.
Align it to the floor cut. |
|
 |
|
February 26, 2005
Here you have to cheat a little, the gap between
the 2 walls is not quite a normal wall panel width.
You will have to cut a 15.5cm X 5.5cm rectangle for
the center unit. |
|
 |
|
|
