October 10, 2004

Now we don't want ugly cardboard peeking through the table top so get out your black marker and cover all 4 sides of the Control Panels.

Do Not stay TOO LONG on the same area, the pen will tend to leak and the Decal and Cardboard will absorb the excess and make blotches.

October 10, 2004

Now take a Control Panel and place it into one of it's grooves.

Take your Hot Glue Gun and squirt a small amount of glue inside the opening between the Foamcore and Cardboard.

October 10, 2004

Carefully press down onto the Lower Layer. The Hot Glue will smoosh with the Control Panel and keep it from falling out.

October 10, 2004

Repeat the Hot Glue Smooshing 11 more times until all 12 Control panels are in place. Looking nice if I do say so myself :D

October 10, 2004

Find the Center of your table using your Angle Ruler.

October 10, 2004

Poke a hole through the Table Surface. This is where the Centerpiece will fit into.

October 10, 2004

I had an extra Darth Vader Interrogation Droid that just happens to be the same size as the Movie Centerpiece, So I simply cut off the Stand and removed the plastic pincers and probes.

BE CAREFULL when cutting the plastic stand. you need A LOT of pressure and can hurt your fingers if done too quickly.

October 10, 2004

Now stick the Probe into the hole in the center of the table.

October 10, 2004

Ta-Dah !!! Your Conference Table is now complete. What do you think? Look pretty cool doesn't it?

October 10, 2004

A small peak at what our figures will look like in the finished Diorama. All thats missing is Walls and some Chairs...