October 10, 2004

Here you see the other side of the Strip and how it looks with the Side Decal in place.

Applying the Decal BEFORE attacking with the Hot Glue gives a cleaner look to the Wall unit.

October 10, 2004

Repeat the procedure with the other Strip. make sure both are alligned with the Top and Back of the Main piece.

October 10, 2004

Remember those 2X 4.5cm pieces you ended up when cutting your strips in photo 063?

Use your Hot Glue Gun to set them in place at the bottom of the Wall Unit. Allign Flush with the Back of the Wall piece . They should fit perfectly in the slots of the Main Unit.

October 10, 2004

Here is what they should look like from the Front View.

October 10, 2004

Take your Bottom Decal section and Hot Glue it to the Bottom of the Wall unit.

October 10, 2004

Here is what it will look like with one exception... The Fold Over piece from Photo 079 will be attached to this piece to avoid a gap.

NOTE that you must Hot Glue ONLY this section. That instruction will remain the same when you use the final Downlaod Decals.

October 10, 2004

On the opposite end of the Wall Unit, Hot Glue the Front Cardboard Top Decal. Make sure to allign with the Top of the Unit.

October 10, 2004

The Top will look like this when you look at it from the front.

October 10, 2004

After assembling this piece I figured it would be more esthetic to have it as one piece of Decal with the Bottom base.

So when you do this part, it will be a fold down, not a seperate piece like in the photo.

October 10, 2004

Now simply fold down the Decal until it presses against the back of the Main Wall Unit.

To help fold the Cardboard, you can do a slight slice with your Xacto Blade in the back of the Decal. Don't press TOO hard or you will slice the Decal in half.