October 24, 2004

Place some Hot Glue on the Tip of the Top Panel Strip and allign it with the Corner Wall Unit's Top Panel (See the Yellow Arrow) and secure into place.

October 24, 2004

Once the Glue hardens, attach the other side of the Strip to the opposite Corner Wall Unit.

October 24, 2004

Time for the Corridor Floor.

I just cut a piece of Foamcore 57.5cm X 16.5cm.

October 24, 2004

Take the same Mac Tac used for the Table Top (step 34 page 4) and apply it to the Foamcore rectangle.

The size of this piece might change in time, once I figure out how to connect all the Death Star Dioramas into one Mega Diorama. For now, let's pretend it is a free standing Diorama. Which you can choose to do. that's what great about modular rooms.

October 24, 2004

Now print out the Neon Wall Decal sheet and apply it to a piece of Foamcore.

October 24, 2004

Use the Hot Glue Gun to attach the Neon Wall to the center of the Corridor Floor.

You might want to make 2 or 3 of these if you want to create a wider backdrop for when you want the Blastdoors to Open Wider.

October 24, 2004

Here is where the Corridor Floor fits with the Main Conference Room.

Note the piece is wider then the door opening so that the Blastdoors can be pulled opened and closed.

October 24, 2004

And here is a front view of the Corridor and the Neon Walls. Look how cool the Mac Tac reflects the Neons just like in the real movie set. :D

October 24, 2004

Here's an inside view with the Conference Room Table set in place. OOPS, the blastdoors aren't made yet :P ... Pretend you don't see them. LOL.

October 24, 2004

Let's make those Blastdoors :)

Print out the KLeft and Right Door Decals. The Top Panels have already been used for the Top Strip. You will be getting your Main Door Decals for this step.