October 31, 2004

Bend those chair backs before you attach them to the chair feet.

For Tarkin's back, roll the FAT marker at the SAME height as the regular chairs.

You DON'T want to bend the LONG rabbit ear shape. ONLY below the punched out hole.

October 31, 2004

About 30 minutes later, our chairs are all assembled but still look like paper - LOL.

October 31, 2004

Get out your paint and start brushing :) I used a dark Paynes Grey. A dark color is just fine. I picked this one because I used it in a previous Diorama.

October 31, 2004

Let the Chair backs dry before tackling the Feet. If not, you will have lovely finger prints all over the chairs and Darth vader will not be happy about that :P

October 31, 2004

WooHooo, Chairs right out of the factory :D

Pretty cool for some paper cardboard don't you think? LOL.

October 31, 2004

Once the feet are dry, you can place them into the Conference Room. Align them up with a Control panel.

Most of you can stop here if you wish. But wait... NiubNiub wants to make a movie accurate Diorama :P Can you guess the last step that's missing?

October 31, 2004

If you said Exhaust Grids and Lights you are Dean On !!! :)

On the back of EACH Wall Unit, you will have to mark a line at 1.5cm and another at 3cm. Then measure 2cm to find the center of the Wall Unit. Then divide each side into 3 equal sections and mark 2 circles above the 2nd lines of each side.

October 31, 2004

Start by making a SLIT into the foamcore with a V Xacto PEN. Make sure that you TAKE YOUR TIME. These cuts must be clean and precise.

October 31, 2004

For each circle, you want to start with a Horizontal Slit into the Foamcore.

October 31, 2004

Then pull out the Xacto Pen and do a Verticle Slit. What you want to do is create a + shape .